Raximo handlebar "Flat Drag Bar" conical 28,6mm with ABE
The extra flat Drag Bar handlebar from Raximo is perfect for conversions for choppers, cruisers and nakedbikes.
and gives your motorbike the individual Drag Star character
High-strength tubular aluminium handlebar
28,6 mm in the clamping area and 22 mm outside
Sealing for easy alignment at the handlebar clamp
dimensions:
Width: 825 mm
Offset to the rear: 100 mm
Outside diameter in the clamping area: 28.6 mm
Outer diameter in the area of the grips: 22.2 mm
Inner diameter: approx. 12 mm
Width approx. at mounting: 220mm
Please note, most fittings have a locking pin in the switch unit, there is no hole in the handlebar, this must be drilled yourself, we have 4mm and 5mm handlebar drilling templates available if required.
Our handlebars are delivered with a German ABE (General Operating Permit), an entry in the vehicle documents is not necessary. If your vehicle is not listed in the ABE, you can have the handlebars approved by your responsible TÜV test centre in accordance with §19.2 StVZO and have them entered in the vehicle documents.
Scope of delivery:
1 x Raximo handlebar "flat Drag Bar".
1 x General type approval
