RAXIMO Alloy handlebar "Street" - 22mm
RAXIMO "Street"
This handlebar is very often used to replace original handlebars, which usually have a steel handlebar installed. The high-strength aluminum alloy goes far beyond the load limits such as the test load required by TÜV / KBA.
Anodizing: The anodizing of the handlebars is done by us in ISO certified companies, the anodizing is subjected to a UV test each month so that we can ensure a consistent quality.
Batch management: Since motorcycle aluminum handlebars are a safety-relevant component, our deliveries are managed and checked according to batches.
ServiceCard: Our aluminum handlebars are delivered with a ServiceCard and serial number. The processing of a customer or service request is thus significantly facilitated and accelerated.
ABE (General Operating Permit): The Raximo Street aluminum handlebars are equipped with an ABE. This means: the installation on motorcycle models that are listed in the ABE, must not be tested again by the TÜV.
Dimensions
- Width: 730 mm
- Height: 90 mm
- Offset to the rear: 70 mm
- Outside diameter in the area of the clamp: 22 mm
- Outside diameter in the area of the grips: 22 mm
- Inner diameter: approx. 12 mm
- Width approx. at the mounting: 130 mm
Technical details
- high-strength tubular aluminum handlebar
- 22 mm Ø in the clamping area and 22 mm outside
- perfect adjustability due to laser engraved scaling
Our handlebars are delivered with a German ABE (General Operating Permit), an entry in the vehicle documents is not required. If your vehicle is not listed in the ABE, you can have the mounting of the handlebars in accordance with §19.2 StVZO at their competent TÜV test center and registered in the vehicle documents.
Scope of delivery
1 x Raximo handlebar "Street
1 x General operating permit