Raximo Tapered Handlebars MX – Ideal for Enduro, Motocross, and Adventure Bikes
These handlebars have been specifically designed for motocross, enduro, and adventure bikes. They are made from a high-strength Ergal aluminum alloy 7075 T6, making it nearly impossible for the handlebars to bend after a tip-over or crash, unlike a "normal" aluminum handlebar.
The high torsional stiffness is also achieved through a 5mm material thickness. For high grip security, the left side of the handlebar is knurled.
The models included in the ABE have been tested by us and the TÜV not only for the material and the execution of the handlebars themselves but also for the cable lengths and lines with the new handlebars. With original parts, installation safety is guaranteed. Handlebars that meet this ABE requirement will be shown to you after selecting the vehicle and marked with a green field above the shopping cart button (model-specific item).
However, the handlebars can also be installed as universal handlebars, but they must then be approved and registered by the TÜV. If the new handlebars extend the path or change the angles, the cables or lines may become too short and need to be upgraded from the aftermarket.
A preliminary check can be carried out before ordering. For this, measure the distance between the center of the handlebar and the right handlebar edge. If this diagonal measurement does not significantly differ from our handlebar measurement, it is very likely that the cables and lines will not change much. Nevertheless, always follow the instructions in the installation manual, especially regarding the radii of the brake lines.
Measurements
- Width: 800 mm
- Height: 120 mm
- Rearward Offset: 75 mm
- Outer Diameter in Clamping Area: 28.6 mm
- Outer Diameter in Grip Area: 22 mm
- Inner Diameter: approx. 12.5 mm
Technical Details
- High-strength aluminum tube handlebar RAXIMO MX
- 28.6 mm Ø in the clamping area and 22 mm outer diameter (tapered)
- Perfect adjustability with laser-engraved scale
Handlebars are delivered with an ABE (General Operating Permit), so an entry in the vehicle documents is not required if the model is listed in the vehicle list of the ABE. If your vehicle is not listed in the ABE, you can have the installation of the handlebar approved according to §19.2 StVZO at your responsible TÜV inspection station and have it entered in the vehicle documents.
Scope of Delivery
- 1 x Raximo Handlebar "MX"
- 1 x National Type Approval